If You Don’t Set Them Correctly

In The Event You Get Your Best 3d Mouse For Fusion 360 Autodesk Student License Activation Repaired?The GPU option allows you to select any supported graphics card on your system to take on the brunt of the tracking process. The resulting speed improvement is especially noticeable on high resolution footage or when tracking large areas. Imagineer’s Planar Tracker technology provides 2D tracking data by tracking planes rather than points. The frame offset is usually already set correctly at the New Project dialog stage, but there may be cases where offsets change, such as adding new clip frames. If you will only be working on a section of the shot you can use the In. Out points to set the range on the timeline. Note that the In and Out points affect the range of the Γœberkey button. You can zoom the timeline to only show you the part between you In. Out points by clicking the Zoom Timeline button. If you are using interlaced footage, set your field separation here to Upper or Lower. Make sure you check your fields match your footage before you close the New Project dialog. If you don’t set them correctly, you cannot modify them and will have to restart the project. This is set to the starting frame number or timecode by default. We recommend to only work with the frames you need, rather than importing very large clips or multiple shots edited together. When rendering back out to the host, there are cases where you may also need to premultiply the alpha using the premultiply options in the plugin interface. Do do this, you generate the tracking data from a layer, as described above in Controlling Tracking Data. If you have a tracked layer in Mocha you can see the output of its surface back in the After Effects interface. Note that you do need to have set up. Tracked the correct layers in order for a render to work back in the host. By default, the starting timeline frame will always be zero, which will not affect your data generation back in After Effects. Choose whether you want to use mattes, renders or any other data from Mocha back in the plugin interface. Even when using multi-point trackers to impart rotation and scale to the roto spline, the results are often unusable if there is any perspective change during the shot. Select Autodesk Fusion 360 so that your are configuring your settings specifically for Fusion 360.